my question is very similar to acroy's recent post. i ran a full battery of test today with the TF100 with these results:
FC 11.0
CC 0
TC 11.O
PH 7.5
TA 70
CH 410
CYA 75
TEMP 60
Water VERY CLEAR
trying to get my SWG adjusted to lower the chlorine a bit but based on the pool caluculator it's at the high end of the range. currently running the pump 10 hrs a day with the SWG set at 10% (adjusted today). pool calculator indicates a CSI of -0.52 which if i'm understanding CSI is still in the acceptable range.
what i'm concerned about just like acroy is the CH. it was up around 400 a couple of months ago and then we had 7 inches of rain in one day and that dropped it back down to 290. it's been on the increase since and just want to clarify if anything needs to be done at this point to lower the CH.
as always, thanks for any feedback!
FC 11.0
CC 0
TC 11.O
PH 7.5
TA 70
CH 410
CYA 75
TEMP 60
Water VERY CLEAR
trying to get my SWG adjusted to lower the chlorine a bit but based on the pool caluculator it's at the high end of the range. currently running the pump 10 hrs a day with the SWG set at 10% (adjusted today). pool calculator indicates a CSI of -0.52 which if i'm understanding CSI is still in the acceptable range.
what i'm concerned about just like acroy is the CH. it was up around 400 a couple of months ago and then we had 7 inches of rain in one day and that dropped it back down to 290. it's been on the increase since and just want to clarify if anything needs to be done at this point to lower the CH.
as always, thanks for any feedback!