- Oct 27, 2010
- 1
My Aqua Rite is showing 0 salt and and instant reading of -0 salt after attempting the recalibration steps. I found on a few site that the Thermistor can cause this problem so I ordered a few and changed it out today with no results. I have cleaned the cell and did not have any build up on the elements.
Pool Temp =85
Cell Volts 30.9
Cell Current .08
Output 100%
AL-0
Software 1.33
After the switch is set to auto and relay clicks i get no readings. Then after a short time i get No Salt and Check Cell. My salt from Pool store was 3800 (I added a bag thinking i was low). Will Display not show any reading if its too high?
I have had the cell now since 2004. I don't want to condem the cell because the average "life" years. Can the cell be bench tested?
Any help would be appreciated.
Pool Temp =85
Cell Volts 30.9
Cell Current .08
Output 100%
AL-0
Software 1.33
After the switch is set to auto and relay clicks i get no readings. Then after a short time i get No Salt and Check Cell. My salt from Pool store was 3800 (I added a bag thinking i was low). Will Display not show any reading if its too high?
I have had the cell now since 2004. I don't want to condem the cell because the average "life" years. Can the cell be bench tested?
Any help would be appreciated.