Hello! We got a new Intellichlor cell at the start of the season (IC40), and whereas the last cell seemed perfect (same model, it's just that the PB messed up and the threads got glued and then stripped), this cell seems a little 'off.'
For one thing, the lights on it show a lower reading than when I test with the salt strips...so it may say our salt is 'Low' when I'm testing that it's actually fine with the strips.
Secondly, when running my pump (and therefore my cell) only 9 hours/day, my chlorine is creeping up to 4ppm. This is with the cell on 20%.
Is there a way to 'back the cell down' further, or should I just manually turn the cell off for a few hours each cycle?
thanks! Todd
For one thing, the lights on it show a lower reading than when I test with the salt strips...so it may say our salt is 'Low' when I'm testing that it's actually fine with the strips.
Secondly, when running my pump (and therefore my cell) only 9 hours/day, my chlorine is creeping up to 4ppm. This is with the cell on 20%.
Is there a way to 'back the cell down' further, or should I just manually turn the cell off for a few hours each cycle?
thanks! Todd