I installed a new poolpilot digital (with SC-48 cell) on a 35,000 gallon inground pool yesterday and have been operating it continually since at 50%. When I run the test poolpilot the cell voltage indicates 0v and 5.0 amps. What would cause the voltage to read 0. Could I possibly have a defective unit. My pool parameters are as follows:
FC-5.0
CC-0.0
pH-7.5
TA-140
CH-240
CYA-60
Salt-2900
Temp-84
I put it in the boost mode for about 30 minutes and ran the test again, but still get 0v. Any input would be appreciated.
FC-5.0
CC-0.0
pH-7.5
TA-140
CH-240
CYA-60
Salt-2900
Temp-84
I put it in the boost mode for about 30 minutes and ran the test again, but still get 0v. Any input would be appreciated.