Hi all, I have been lurking for a couple months, learning about how to get my pool chemicals right. I found out I need to backflush quite a bit of water out of my pool due to hardness but my push/pull valve was jammed up. I finally was able to disassemble it and the o-rings are shot.
I have been looking everywhere for replacements and have not had much luck. Can someone help?
Here is my best guess at the o-ring specs based on the slot they are supposed to fit into:
1 5/16 I.D. or 33.3375 mm I.D.
1 13/16 O.D. or 46.0375 mm O.D.
1/4 Wall or 6.35 mm Wall
I am going to have to replace the entire valve? I can't find o-rings anywhere and my pool is starting to get very dirty.
Thanks in advance,
Dan
I have been looking everywhere for replacements and have not had much luck. Can someone help?
Here is my best guess at the o-ring specs based on the slot they are supposed to fit into:
1 5/16 I.D. or 33.3375 mm I.D.
1 13/16 O.D. or 46.0375 mm O.D.
1/4 Wall or 6.35 mm Wall
I am going to have to replace the entire valve? I can't find o-rings anywhere and my pool is starting to get very dirty.
Thanks in advance,
Dan