Hi all.
Here is Arizona we have many dust storms that really fill the air as well as fills the pool.
I have an inground pool with infloor clearer jets. The pool is about 2 1/2 years old.
Preparing the pool to open soon I have noticed staining on the rounded edge inside the pool between the floor and walls on just the south and west side of the pool.It doesn't look like black agea because it is around the areas my infloor system seems to collect the dirt which I sweep into the main dain.
Some areas has like a ripple effect like small waves. I will try and get a photo.
When the sun is overhead the stains seems to be gone.
Chemistry has been tested and all is fine
FC 4
TC 4
PH 7.6
Alk 100
Hardness 250
CYA 80-100
Phospates .000
Water temp 75 degrees
Water is clear and bright
Should I worry or continue to monitor?
Any suggestions from folks in Arizona that may have similiar issues.
Thanks
Here is Arizona we have many dust storms that really fill the air as well as fills the pool.
I have an inground pool with infloor clearer jets. The pool is about 2 1/2 years old.
Preparing the pool to open soon I have noticed staining on the rounded edge inside the pool between the floor and walls on just the south and west side of the pool.It doesn't look like black agea because it is around the areas my infloor system seems to collect the dirt which I sweep into the main dain.
Some areas has like a ripple effect like small waves. I will try and get a photo.
When the sun is overhead the stains seems to be gone.
Chemistry has been tested and all is fine
FC 4
TC 4
PH 7.6
Alk 100
Hardness 250
CYA 80-100
Phospates .000
Water temp 75 degrees
Water is clear and bright
Should I worry or continue to monitor?
Any suggestions from folks in Arizona that may have similiar issues.
Thanks