All,
My conversion is not doing well, the water is very blue but hazy, I can't see the bottom so I doubled up on bleach and now its too high and holding. I tested with a TF-100 kit and had problems with the TA. The instructions say to add R-0009 until the solution turns red. My was only yellow, never turned red, even after 100 drops. A TA test with an HTH 6 way strip says its 120. These are the rest of my values:
FC 39
CC 2
PH 7.3
TA 120????
CH 140
CYA 50
Salt 3850
SWG still off
dissapointment high
What now? go back to Baquacyl? hehehe, riiiiiight!
Roberto
My conversion is not doing well, the water is very blue but hazy, I can't see the bottom so I doubled up on bleach and now its too high and holding. I tested with a TF-100 kit and had problems with the TA. The instructions say to add R-0009 until the solution turns red. My was only yellow, never turned red, even after 100 drops. A TA test with an HTH 6 way strip says its 120. These are the rest of my values:
FC 39
CC 2
PH 7.3
TA 120????
CH 140
CYA 50
Salt 3850
SWG still off
dissapointment high
What now? go back to Baquacyl? hehehe, riiiiiight!
Roberto