Hello I am a new poster, but have been following for about 2 weeks this site. I have conflicting information on what to set my chemistry for SWG. I went to the pool school and read the basic article on setting the chemistry for SWG.
PS
TA 60-90 ppm
PH 7.5-7.6
CH 300
CYA 70-80
Resilence recommends
TA 110-180
CYA 60-80
Salt 3000-4000
Current Readings
FC 2
PH 8 (Just added 30 oz of MA)
TA 100 (not sure it I should count 1/3 of CYA amount?)
CH 225
CYA 60
Salt 4500
Setting only on 10 %
Temp 86 F
I am not sure if I should follow the PS of my manufacturer? I do have some scale on sides and bottom, but that is because I let it go and did not test consistently. I will look into this at some time soon. I do not want to do an acid wash so I am thinking about looking at Jack's Magic and a go stainless steel brush. Any advice is greatly appreciated. Luv FAS-DPD, but want to give Colr Q a chance. It is off, but in the ball park with the accuracy specs.
PS
TA 60-90 ppm
PH 7.5-7.6
CH 300
CYA 70-80
Resilence recommends
TA 110-180
CYA 60-80
Salt 3000-4000
Current Readings
FC 2
PH 8 (Just added 30 oz of MA)
TA 100 (not sure it I should count 1/3 of CYA amount?)
CH 225
CYA 60
Salt 4500
Setting only on 10 %
Temp 86 F
I am not sure if I should follow the PS of my manufacturer? I do have some scale on sides and bottom, but that is because I let it go and did not test consistently. I will look into this at some time soon. I do not want to do an acid wash so I am thinking about looking at Jack's Magic and a go stainless steel brush. Any advice is greatly appreciated. Luv FAS-DPD, but want to give Colr Q a chance. It is off, but in the ball park with the accuracy specs.