Hope I can get a little help wiring up the new 2 speed motor I just recieved. WFE-8 motor is being switched out for a B2984 AO smith 2 speed 2hp motor. 240V wiring.
I have an aqualogic PS4 controller. I know these controllers have the capability of controlling a 2 speed motor. I just need to figure out how to wire it up. If that proves to complicated for a novice I can bring in a pool electrician, hopefully not necessary. For now I can live with running the motor on low speed for pool filtering and manually switching to high speed for spa use I guess by putting in a switch if needed.
here is how the wiring looks for the current set up and the terminals for the new pump on the right.
[attachment=1:246iajpp]WiringDiagram.jpg[/attachment:246iajpp]
If I wanted to just treat this pump as single speed using the low speed how would I wire it up.
Thanks for the help
EDIT/UPDATE
Found this Diagram in manual
[attachment=0:246iajpp]Aqualogic diagram.doc[/attachment:246iajpp]
and was wondering how I would "branch" out the wires leading too and from the terminals as shown in diagram by the solid dot where wires cross. Also I dont have free AUX relay at this time as they are taken up by lighting and water feature but could switch them out to operate manually later.
I have an aqualogic PS4 controller. I know these controllers have the capability of controlling a 2 speed motor. I just need to figure out how to wire it up. If that proves to complicated for a novice I can bring in a pool electrician, hopefully not necessary. For now I can live with running the motor on low speed for pool filtering and manually switching to high speed for spa use I guess by putting in a switch if needed.
here is how the wiring looks for the current set up and the terminals for the new pump on the right.
[attachment=1:246iajpp]WiringDiagram.jpg[/attachment:246iajpp]
If I wanted to just treat this pump as single speed using the low speed how would I wire it up.
Thanks for the help
EDIT/UPDATE
Found this Diagram in manual
[attachment=0:246iajpp]Aqualogic diagram.doc[/attachment:246iajpp]
and was wondering how I would "branch" out the wires leading too and from the terminals as shown in diagram by the solid dot where wires cross. Also I dont have free AUX relay at this time as they are taken up by lighting and water feature but could switch them out to operate manually later.