PB did not plumb the inlets to the pump as requested. Can't get him to change it, so I'll do it myself. I want to place a 3 way valve basically where the left most T is located so I have the Spa Drain on one inlet, and the Pool intakes (drain, skim and vac) on the other valve inlet. The reason is to add an actuator.
As you can see, there is no room. Its all T's and 90s. Is there any way to save them? You can not buy just the valve body for those vavles. If I could glue on a fitting around the outside of the T, that would work. But the OD of these 2" fittings are 2.72 and the ID of 2.5" fitting is 2.875, which is too great a difference. I could machine a sleave 1/16" thick to fit, but I'm not sure that is such a good idea.
Any ideas?[attachment=0:16pgdey9]P8252973.jpg[/attachment:16pgdey9]
As you can see, there is no room. Its all T's and 90s. Is there any way to save them? You can not buy just the valve body for those vavles. If I could glue on a fitting around the outside of the T, that would work. But the OD of these 2" fittings are 2.72 and the ID of 2.5" fitting is 2.875, which is too great a difference. I could machine a sleave 1/16" thick to fit, but I'm not sure that is such a good idea.
Any ideas?[attachment=0:16pgdey9]P8252973.jpg[/attachment:16pgdey9]