I have a new Autopilot Digital with the SC-48 cell. It was installed two days ago. I ran my pump for the first 24 hours and did not get much of a chlorine reading. I then ran it for 12 hours the next day and g0t a reading of almost 1. Wonder what I should do, I was thinking of one of the following:
1. Don't panic give it another couple of days (makes me nervous because I live is Arizona - Temperature is 102)
2. Shock with a gallon or 2 of bleach.
3 Shock with MPS.
4. Run the AutoPilot in Boost mode.
PH 7.2
ALK 130
CYA 90
Hardness 350
FC 1
Salt 3300 PPM
17,000 Gallons
Water is clear (amazing at this chlorine level in this heat)
Cell is at Level 3 - 50% (upped it based on low chlorine after two days)
Thanks,
Mark
1. Don't panic give it another couple of days (makes me nervous because I live is Arizona - Temperature is 102)
2. Shock with a gallon or 2 of bleach.
3 Shock with MPS.
4. Run the AutoPilot in Boost mode.
PH 7.2
ALK 130
CYA 90
Hardness 350
FC 1
Salt 3300 PPM
17,000 Gallons
Water is clear (amazing at this chlorine level in this heat)
Cell is at Level 3 - 50% (upped it based on low chlorine after two days)
Thanks,
Mark