Hi all!
I have a 2012 Marquis Celebrity spa with an Aquaflow XP2 2 speed 115v pump motor using Balboa BP series controls (maybe BP500 equivalent?) labeled MQREVUM -PN 56286 that is wired for 120v and has been installed and running for over a year. The top display/control panel looks like the Balboa TP400T, could be a different model but mine looks exactly like it with the button setup.
Last month my heater element died and I just put in a replacement. Now that I have it back up and running it says it's running on 240v and my low speed filter setting won't run but the light comes on, I hit the button again and the high speed kicks on and the jets run.
The label inside the enclosure cover shows setup #1 which I verified it's on but I can't figure out where my issue is if my low speed burned out or my circuit board or programming is messed up. It's on a 120v cord with a GFCI plug on a 15amp 120v breaker as required so I don't see how it's trying to run at 240v.
Any help is appreciated.
I have a 2012 Marquis Celebrity spa with an Aquaflow XP2 2 speed 115v pump motor using Balboa BP series controls (maybe BP500 equivalent?) labeled MQREVUM -PN 56286 that is wired for 120v and has been installed and running for over a year. The top display/control panel looks like the Balboa TP400T, could be a different model but mine looks exactly like it with the button setup.
Last month my heater element died and I just put in a replacement. Now that I have it back up and running it says it's running on 240v and my low speed filter setting won't run but the light comes on, I hit the button again and the high speed kicks on and the jets run.
The label inside the enclosure cover shows setup #1 which I verified it's on but I can't figure out where my issue is if my low speed burned out or my circuit board or programming is messed up. It's on a 120v cord with a GFCI plug on a 15amp 120v breaker as required so I don't see how it's trying to run at 240v.
Any help is appreciated.