Need some help on my new I1. Only been running for a week now. was installed over the winter and pool was opened last week. Pump ran fine and seemed to follow the schedules. Went out of town and came back to 0 RPM. tried to reset and then keep receiving a "Priming Failure" alarm with number B70021. plenty of water is flowing through. Shut it down fully cleaned basket (which was not dirty) and filters (since I just opened). however, given i follow TFP, my pool was fairly clean when opened and spotless on day 2.
Interestingly, when i try to start the pump in preset 2, the pump will prime and run and I can adjust the RPM. however, from there when it hits its next schedule point, it goes to 0 RPM. when i try to start during that schedule, I get a Priming Failure code.
I have it scheduled as follows:
6:01 am - 11 at 2000
11:01 am - 10 pm 2600
10:01 - 2: 00am 3200
2:01 - 6:00 am 3200 (if pressure cleaner is scheduled otherwise disabled)
2:01 - 11:00 am at 2000 (if pressure cleaner is not scheduled and using robot)
my pressure cleaner is on its last leg and I use it while out of town since I dont want to leave the robot unattended.
any help would be much appreciated.
thanks
Interestingly, when i try to start the pump in preset 2, the pump will prime and run and I can adjust the RPM. however, from there when it hits its next schedule point, it goes to 0 RPM. when i try to start during that schedule, I get a Priming Failure code.
I have it scheduled as follows:
6:01 am - 11 at 2000
11:01 am - 10 pm 2600
10:01 - 2: 00am 3200
2:01 - 6:00 am 3200 (if pressure cleaner is scheduled otherwise disabled)
2:01 - 11:00 am at 2000 (if pressure cleaner is not scheduled and using robot)
my pressure cleaner is on its last leg and I use it while out of town since I dont want to leave the robot unattended.
any help would be much appreciated.
thanks