Have a 20K gallon in-ground vinyl pool - new to me since August. Water purity has been great - thanks to advice from this forum and the Taylor K-2006C kit.
Getting ready to close - and following the threads on this forum plan to follow 7 steps:
1) Set water conditions
2) Drop water level
3) Drain filter
4) Blow water out of lines
5) Plug lines
6) Store pump inside
7) Cover pool
'Found' various plugs and other parts in garage (see image) ... It seems most of these are to plug lines - but not sure where the wingnut-seals go (2 sizes, 3 of each) and where the 9 foam inserts go (also 2 sizes - 6 large 3 small). I am guessing the 2 hard plastic slotted seals go the two heater lines entering the house?
My Question - how do I match the parts to the pipes/pool for a safe closing?
For the 'Heater' lines going into and out of house - do I keep these full of water or blow the water out of these lines as well?
Getting ready to close - and following the threads on this forum plan to follow 7 steps:
1) Set water conditions
2) Drop water level
3) Drain filter
4) Blow water out of lines
5) Plug lines
6) Store pump inside
7) Cover pool
'Found' various plugs and other parts in garage (see image) ... It seems most of these are to plug lines - but not sure where the wingnut-seals go (2 sizes, 3 of each) and where the 9 foam inserts go (also 2 sizes - 6 large 3 small). I am guessing the 2 hard plastic slotted seals go the two heater lines entering the house?
My Question - how do I match the parts to the pipes/pool for a safe closing?
For the 'Heater' lines going into and out of house - do I keep these full of water or blow the water out of these lines as well?