Found my Pentair VS pump started randomly, and I think has been, as a result of my AquaLink RS anti freeze function - just noticed last weekend. Only way to get it to turn off was to “clear memory” from the control panel in our house. I think I have 75% set back up, and anti freeze set to lowest degrees (I live in SoCal so not to concerned about it freezing)…
VS speed pump is set to run slow and long all night. After resetting it I have it running at 900 RMP starting at 1AM and I think till 8AM. I took a look at around 5 this morning and saw the spa was 3/4 full (Not filling back up) and the window on the pump showed half full. So a couple questions below on this and more.
- Pentair VS Pump
- Jandy JVA 2444
- Aqualink RS controller
- Has anyone had issues with the programmed run time not run? I set the pump to run every day, but wasn’t running yesterday when I woke. It seems to randomly stop. Ironically the first night I didn’t check at 2AM and again when I get up at 5….;(
- As mentioned above spa seems to empty unless I have
- Anyway to monitor runtime? to see if it stops at all over the night, or if it starts during the middle of the day.
I have the manual, for the Aqualink, but doesn't seem to give a lot of detail..
thanx
VS speed pump is set to run slow and long all night. After resetting it I have it running at 900 RMP starting at 1AM and I think till 8AM. I took a look at around 5 this morning and saw the spa was 3/4 full (Not filling back up) and the window on the pump showed half full. So a couple questions below on this and more.
- Pentair VS Pump
- Jandy JVA 2444
- Aqualink RS controller
- Has anyone had issues with the programmed run time not run? I set the pump to run every day, but wasn’t running yesterday when I woke. It seems to randomly stop. Ironically the first night I didn’t check at 2AM and again when I get up at 5….;(
- As mentioned above spa seems to empty unless I have
- Pull from Pool @ 100%
- Return to Spa @ 100%
- Unless the valve is so sensitive that I just have to play with it and find the right setting. Then How to lock that in for my overnight run..
- When configuring the Spa mode how to we set the position of the JVA’s?- Anyway to monitor runtime? to see if it stops at all over the night, or if it starts during the middle of the day.
I have the manual, for the Aqualink, but doesn't seem to give a lot of detail..
thanx