Hey guys, I'm doing a job and have installed an Easytouch to control 6 fire bowls (2 zones), 1 fire pit (1 zone), and a heater (all propane of course). It does NOT control the pump.
It has Screenlogic, which to be honest I feel is the only way I would try programming this thing. The touch screen is a pain.
Last night I was setting the "Run-Once" setting and noticed there is no "Stop Time". The only way to get the this schedule to stop when I wanted to was to use the "Egg Timer", which to me kind of defeats the purpose doesn't it? I read the manual and it says there should be a "Stop Time" setting, but can't figure how to get it to work?
Any ideas?
P.S. - If I set the "Egg Timer" to "Don't Stop", the "Run-Once" defaults to 3 hours, as you can see.
Also, disregard the "Pool" circuit, as it's still active so I can control the heater.
It has Screenlogic, which to be honest I feel is the only way I would try programming this thing. The touch screen is a pain.
Last night I was setting the "Run-Once" setting and noticed there is no "Stop Time". The only way to get the this schedule to stop when I wanted to was to use the "Egg Timer", which to me kind of defeats the purpose doesn't it? I read the manual and it says there should be a "Stop Time" setting, but can't figure how to get it to work?
Any ideas?
P.S. - If I set the "Egg Timer" to "Don't Stop", the "Run-Once" defaults to 3 hours, as you can see.
Also, disregard the "Pool" circuit, as it's still active so I can control the heater.