This is my first post here, so I hope it's in the right spot. I'm looking for expertise on the Frog Leap System. We just had our pool installed last month (July 18) and we have this, in my opinion, waste-of-money system. I have continually adjusted the dial down to where it is now just a fraction above the "zero" setting. My chlorine has never strip-tested below 3ppm, unless the chlorine pac is empty or close to it. We just had 4.5" of rain this passed weekend and it was still reading 5ppm the next day.... I've never shocked it since install
I've mentioned this twice to our pool place and they act like it's OK. I have a hard time believing this is normal. I've read the manual and the chart on there says our's (32x16 oval or 12,500 gal) should be set between 4-6, depending on pump run. Like I said, I'm set below 1.
Any input is appreciated
Sent from my XT907 using Tapatalk
I've mentioned this twice to our pool place and they act like it's OK. I have a hard time believing this is normal. I've read the manual and the chart on there says our's (32x16 oval or 12,500 gal) should be set between 4-6, depending on pump run. Like I said, I'm set below 1.
Any input is appreciated
Sent from my XT907 using Tapatalk