Hi all, quick question: My T15 cell with Aqualogic controller is giving me an occasional High Salt/Amps error code when I have the valves set to SPA. I have never seen the error in Pool mode. Is this an early sign that my board needs to be resoldered/replaced? Is there some unpublished minimum number of gallons required for proper operation?
I run the SWG on a timer while in SPA mode. I have plenty of water exchange between the pool/spa during the spillover cycle so I'm not overly concerned with hot tube chlorine levels. Do I just shut off the SWG in SPA mode or is this a sign of a worse failure mode to come?
Salt level is at 3700 per the TF100 add on salt test which agrees +-100 with the SWG readout when it is functioning correctly.
I appreciate any thoughts or insight!
CFM
I run the SWG on a timer while in SPA mode. I have plenty of water exchange between the pool/spa during the spillover cycle so I'm not overly concerned with hot tube chlorine levels. Do I just shut off the SWG in SPA mode or is this a sign of a worse failure mode to come?
Salt level is at 3700 per the TF100 add on salt test which agrees +-100 with the SWG readout when it is functioning correctly.
I appreciate any thoughts or insight!
CFM