I have a new iAqualink 2.0 set up with 3 Jandy watercolor LED's. 2 in the pool, 1 in the spa. So far I have the software set up, and the device is connected to my network correctly. I can turn on the spa and such from my iphone.
On the board, the installer for some reason installed the lights on the solar circuit. In service mode, at the panel, I can cycle the lights on and off through all the color options by pressing the solar button.
When I try to control the lights via my iphone, I run into problems. The lights do turn on and off, but I am unable to really cycle between the light colors. It's controlled through and extra Aux tab, that I have to turn on and off to get it to even attempt to cycle.
On the Jandy website, they show a page on the app that allows you to select the color you want to see. I have no such page on my app. I have gone through the web page set up, and assigned the right light code to the extra aux button.
What am I doing wrong?
On the board, the installer for some reason installed the lights on the solar circuit. In service mode, at the panel, I can cycle the lights on and off through all the color options by pressing the solar button.
When I try to control the lights via my iphone, I run into problems. The lights do turn on and off, but I am unable to really cycle between the light colors. It's controlled through and extra Aux tab, that I have to turn on and off to get it to even attempt to cycle.
On the Jandy website, they show a page on the app that allows you to select the color you want to see. I have no such page on my app. I have gone through the web page set up, and assigned the right light code to the extra aux button.
What am I doing wrong?