So I've tried for over 2 hours with no luck. I think I followed all the steps but I'm new to owning a pool. Any help would be much appreciated.
Steps I've taken
1. Power wires from pump connected directly to the breakers
2. Disabled the display panel on the pump by unplugging the terminal block that is connected to the RS485
3. Ran Red and white wire from the RS485 on the pump in the A/B slots to the low voltage on the Omnilogic in the 2/3 position
4. Went into the Omnilogic to configure the pump and the Omnilogic can't find the HUA address
What am I missing?
Bill
Steps I've taken
1. Power wires from pump connected directly to the breakers
2. Disabled the display panel on the pump by unplugging the terminal block that is connected to the RS485
3. Ran Red and white wire from the RS485 on the pump in the A/B slots to the low voltage on the Omnilogic in the 2/3 position
4. Went into the Omnilogic to configure the pump and the Omnilogic can't find the HUA address
What am I missing?
Bill