Just bought my Taylor K2006 and these are my results:
FC 3.6ppm
CC .2
Ph 7.7
TA 140
CH 290
CYA 82
I know my CYA is high and my FC is too low and I need to raise my FC to at least 7ppm. The pool calculator says i need to add 123 oz of bleach 6%. Can i add bleach although I havent switched over from disconnecting my fusion Nature 2, yet? If not what impact would poolife rapid shock have on pool chemistry. The fusion is set to 1 to reduce the use of the pucks. I know the majority dont support ozonators and thrichloro, unfortuantely i did not find this site until after my pool was already being built. My plan is to bypass the fusion pucks and empty the mineral pack, i haven't had the opportunity to do this,yet. Thus, am I at the point where I need a partial pool drain to get my CYA under control?
FC 3.6ppm
CC .2
Ph 7.7
TA 140
CH 290
CYA 82
I know my CYA is high and my FC is too low and I need to raise my FC to at least 7ppm. The pool calculator says i need to add 123 oz of bleach 6%. Can i add bleach although I havent switched over from disconnecting my fusion Nature 2, yet? If not what impact would poolife rapid shock have on pool chemistry. The fusion is set to 1 to reduce the use of the pucks. I know the majority dont support ozonators and thrichloro, unfortuantely i did not find this site until after my pool was already being built. My plan is to bypass the fusion pucks and empty the mineral pack, i haven't had the opportunity to do this,yet. Thus, am I at the point where I need a partial pool drain to get my CYA under control?