Hello all,
I have just erected a new intex ultra 14 x 42 on level ground ( owned a regular blue before ).
Everything was going well ( wrinkles came out and water seemed even etc. ) However when there was about an inch of water in there I noticed the bottom of the pool liner would not go flat to the thicker side walls in a few places. ( side walls not touching ground )
I am worried that if I continue to fill ,the bottom liner will push out under the sides and burst. Now, I have never noticed this problem before on my previous blue pool. Also some of the legs pull in when I straighten the others . I am worried that I have not centred the liner properly or it might be a faulty liner . Am I being paranoid or can the bottom liner handle the pressure ?
Any advice would be welcome.
Gilly:
I have just erected a new intex ultra 14 x 42 on level ground ( owned a regular blue before ).
Everything was going well ( wrinkles came out and water seemed even etc. ) However when there was about an inch of water in there I noticed the bottom of the pool liner would not go flat to the thicker side walls in a few places. ( side walls not touching ground )
I am worried that if I continue to fill ,the bottom liner will push out under the sides and burst. Now, I have never noticed this problem before on my previous blue pool. Also some of the legs pull in when I straighten the others . I am worried that I have not centred the liner properly or it might be a faulty liner . Am I being paranoid or can the bottom liner handle the pressure ?
Any advice would be welcome.
Gilly: