I have a 2007 hydropool 650. The tub was getting an ohh error and the sensor was reading much higher than actual temperature. I could still use the topside panel and the error would go away after a while once the water cooled slightly. I have determined that it is likely faulty heat sensors so I have some on order . The OHH sensor is now permanent and I can't reset or do anything. Tried resetting the breaker resetting memory ect ect but the error keeps coming up and I can't do anything with the top side panel.
I want the pumps to run so water continues to circulate but I can't do anything. Is there anyway to bypass or allow the pumps to run without the heater or sensors operational ? Sensors won't arrive for a few days and I want to make sure I at least have filter cycles on.
I want the pumps to run so water continues to circulate but I can't do anything. Is there anyway to bypass or allow the pumps to run without the heater or sensors operational ? Sensors won't arrive for a few days and I want to make sure I at least have filter cycles on.