As a new pool owner I was excited that my pool came with an Pentair automation system. This should make it easier for the newbie, right?
Things were going along just fine for 6 months. Then a rather large thunderstorm came through. Power was lost in the whole house.
When checking on the pool it appeared that the pump was coming on at the wrong time. Simple fix. Set it to the correct time.
Wow, that was easy. Or so I thought.
I grab my EasyTouch remote and select spa. Green light on remote. Nothing appeared to be changing. So, I go back to the equipment
to take a look. The valves did not change from Pool to Spa. The heater, MiniMax NT, did begin its start up cycle.
Not knowing if this is a power outage issue or user induced issue, how would I go about checking the programming of that button?
Thank you in advance for your assistance.
Things were going along just fine for 6 months. Then a rather large thunderstorm came through. Power was lost in the whole house.
When checking on the pool it appeared that the pump was coming on at the wrong time. Simple fix. Set it to the correct time.
Wow, that was easy. Or so I thought.
I grab my EasyTouch remote and select spa. Green light on remote. Nothing appeared to be changing. So, I go back to the equipment
to take a look. The valves did not change from Pool to Spa. The heater, MiniMax NT, did begin its start up cycle.
Not knowing if this is a power outage issue or user induced issue, how would I go about checking the programming of that button?
Thank you in advance for your assistance.