I have a SWG pool, about 30,000 gallons. At the start of the season the pump's motor got fried and it took me about 6 weeks to replace it.
i installed iAquaLink before that, and everything is now working fine.
For the past 2 weeks I have vacuumed, cleaned the cartridge filters, cleaned the Polaris, etc probably ten times. There was a lot of sediment at the bottom of the pool, so it was necessary.
I seem to have a problem where the flow changes during the day on its own. It starts out strong, water spills over the spillway and all looks well. Hours later it turns into a dribble over the spillway and I get a no flow indicator. The contacts on the flow sensor are clean.
I now have the pump at 2500 rpm and I am getting good water movement..
Finally, I have noticed that when the cleaner is on it will choke the water flow. I thought that cleaners with a booster pump were less dependent on rpm of the main pump?
This is somewhat vague, but something just doesn't seem right. I thought you all might have some insights that would be helpful. Any ideas?
Thank you all so much.
i installed iAquaLink before that, and everything is now working fine.
For the past 2 weeks I have vacuumed, cleaned the cartridge filters, cleaned the Polaris, etc probably ten times. There was a lot of sediment at the bottom of the pool, so it was necessary.
I seem to have a problem where the flow changes during the day on its own. It starts out strong, water spills over the spillway and all looks well. Hours later it turns into a dribble over the spillway and I get a no flow indicator. The contacts on the flow sensor are clean.
I now have the pump at 2500 rpm and I am getting good water movement..
Finally, I have noticed that when the cleaner is on it will choke the water flow. I thought that cleaners with a booster pump were less dependent on rpm of the main pump?
This is somewhat vague, but something just doesn't seem right. I thought you all might have some insights that would be helpful. Any ideas?
Thank you all so much.