I just finished installing all my new equipment, Intelliflo Vf, Quad DE 100, Pool Pilot digital and all new 2" piping.
I did all the plumbing first, then the electric. Then I took off the cover and removed the bolts (2 returns, 1 in each of 2 skimmers, 2 for booster pump.
Turned on power and intelliflo lit right up. Took of the cover and attempted to fill basket with water. It only fills up to bottom of where the piping comes in, then put the cover back on. I clicked on manual mode and set GPM to the first setting that came up which I believe was 50gpm.
Hit the start button and the pump kicks in, pulls just about all the water out of the basket but will not suck in any water. I let it run for a few minutes but nothing. I tried it with the relief valve on the filter open and closed, but that didn't make a difference. I checked make sure my Jandy valves were open as well.
What am I doing wrong?????
I did all the plumbing first, then the electric. Then I took off the cover and removed the bolts (2 returns, 1 in each of 2 skimmers, 2 for booster pump.
Turned on power and intelliflo lit right up. Took of the cover and attempted to fill basket with water. It only fills up to bottom of where the piping comes in, then put the cover back on. I clicked on manual mode and set GPM to the first setting that came up which I believe was 50gpm.
Hit the start button and the pump kicks in, pulls just about all the water out of the basket but will not suck in any water. I let it run for a few minutes but nothing. I tried it with the relief valve on the filter open and closed, but that didn't make a difference. I checked make sure my Jandy valves were open as well.
What am I doing wrong?????