I am moving my hot tub and want to go to the 60 amp service so I can run both pumps and the heater at the same time. I have run all the wire to the disconnect and the hot tub with 60 amp service. My question is on the jumper JP9 #7, it shows that needs to be jumped for 60 amp service. Is that all I have to do or do I have to remove another jumper that was set for 50 amp as it was originally configured? Sundance told me that JP9 #7 needed to be jumped, which I did, I'm just wondering if I have to do anything else. The jumper was already there it was just on one pin I simply put it on both pins, I'm thinking that is all I have to do but I want to know if somebody can confirm. Thanks for any help. I have yet to fill my hot tub, I want to make sure this before I apply the power.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk