I installed a new Pentair VS Pump and motor this August. The rains just came through the Houston area and water got into the VS drive circuit panel. Now the pump is down. The rubber gasket was in place but water came through anyway and now there are at least 3 separate shorted spots on the board.
Does anyone know how to bypass the VS drive and power the pump until a new panel can be purchased?
Does anyone know if I can just replace the circuit board and not buy the whole VS drive package. Looks like the stores want to only sell the whole drive for about half the cost of a new pump and motor.
The pump is the Pentair Intelliflo VS 354605.E (p/n 0110018) built 5/14/2015. Any thoughts or advise greatly appreciated.
Does anyone know how to bypass the VS drive and power the pump until a new panel can be purchased?
Does anyone know if I can just replace the circuit board and not buy the whole VS drive package. Looks like the stores want to only sell the whole drive for about half the cost of a new pump and motor.
The pump is the Pentair Intelliflo VS 354605.E (p/n 0110018) built 5/14/2015. Any thoughts or advise greatly appreciated.