So I have to admit, I fell off the TFP wagon for about two weeks. Been fighting a pump issue that I finally got resolved tonight. (I have to say, those that watch the testing and balancing side of this forum are considerably more responsive than the equipment side of the forum. Could be though that my question was so elementary that they assumed I would just figure it out). Anyway, with the help of TFP, this is probably the first time in 4 years that the floor of the deep end of my pool can be seen. After the two week hiatus over my pump, here are my test results.
FC, TC, & CC - 0
CYA - 5 or less
PH -8.4
TA - 240
CH - 75
Though the pool is clear, I can see algae spots forming down the sides and around the returns. I've been fighting keeping CYA in the pool, but may have dropped due to the significant drain while repairing pump. I'm concerned that the TA is too high and the CH is too low. I need to get bleach into it ASAP as well as a gal of muriatic. I cant get it in my sig, but it's a 40k gal in ground plaster pool with a Hayward Sand Filter and a pentair 2hp pump. Thoughts?
Sent from my SAMSUNG-SM-G870A using Tapatalk
FC, TC, & CC - 0
CYA - 5 or less
PH -8.4
TA - 240
CH - 75
Though the pool is clear, I can see algae spots forming down the sides and around the returns. I've been fighting keeping CYA in the pool, but may have dropped due to the significant drain while repairing pump. I'm concerned that the TA is too high and the CH is too low. I need to get bleach into it ASAP as well as a gal of muriatic. I cant get it in my sig, but it's a 40k gal in ground plaster pool with a Hayward Sand Filter and a pentair 2hp pump. Thoughts?
Sent from my SAMSUNG-SM-G870A using Tapatalk