temp sensor

I'm not finding in the stack of manuals a clear model # for replacing a Pentair water temperature sensor that connects to our Intellicenter to regulate a Mastertemp spa heater. Is the correct model 520272? Is OEM a requirement or are there other contenders that would work just fine given how...

So I heated my pool on Sat to 86, then turned it off Sat night. Wake up Sun morning to 81. Then started heating on Sun afternoon to 86. Turned it off Sunday night. It has since been constant at 81. I would expect at least a degree here or there. If I start heating the pool, it starts going up...

Need some guidance on this one. Temperature sensors/display. I've been working around HI Temps. I know this much. There are 3 temp sensors in my Omnilogic system. 1. Air Temp My sensor is Dangling under the Omnilogic case. 2. Water Temp installed in the 2" water pipe just after the...

This appears to only happen in unusually cold weather for Tampa, but the solar sensor I installed with our new panels is giving out impossibly high readings at night and early morning - whenever the air temperature goes below 50-55 degrees. It's quite accurate during the day (as tested by a...

Hello All, Symptom is a temp sensor shorted message with temp showing 231. Sensor is 12K Ohms disconnected at the board and not shorted to ground. I left the wires off and powered up. The message is open sensor? When I reconnected and powered up, it showed normal temp for 10-15 seconds...