Search results

after weeks of trying to trouble shoot and my PB saying 20PSI on the filter was normal I swapped out the filter. After that everything started working properly. The PSI on the filter dropped to 14 as soon as I put a clean filter in.

I think there is still a flow issue as the Salt Cell keeps getting a no flow alarm. So until the flow coming out of the filter is up adding a flow switch for heater won't make any difference. If I can't get the salt cell on then the heater will have the same issue.

The filter is a swim clear 150s https://www.hayward-pool.com/shop/en/pools/res-in-ground/res-filters/swimclear-single-element-i-seswim I am going to swap the filter out later today. Its been cleaned regularly but 20PSI seems like part of the issue.

the question I have is why would only 2 of the 4 returns have flow at any given time. You have to close off the 2 closest to the pump to get flow from the 2 furthest when the pump is at 100%.

230Volt MaxFlow 500 VSP https://hayward-pool-assets.com/assets/documents/pools/pdf/literature/DLITMFVS50019-maxflo-vs-sell-sheet-update-062019.pdf aside from the heater issue the pool has 4 returns 2 have a strong output, 1 has very minimal and 1 has none. Which is why I was thinking the pump...

The builder was back out this week. They closed 2 of my 4 returns and still didn't solve the issues and I think will cause problems long term as my only returns are now on the end of the pool opposite the skimmer. Nothing on the sides mid pool. They "think" its a bad pressure switch though I am...

I’m holding off right now my PB is still working with Hayward. The changes the eyeballs to smaller ones and if you restrict the flow to the returns the heater runs. I’ve told my PB this isn’t acceptable and they need to correct the install. The other issue has been the salt cell will only run at...

is the the right part? http://www.inyopools.com/Products/07501352049459.htm

150 BTU

thanks for the help. Waiting on my PB to come back with a solution before I suggest the change. He did good work on the install but there has been a number of smaller issues that have had to be run down. I know the pressure sensor is easy to swap and key is to get the desired state that no water...

I have a newly installed Hayward H Series heater. My PB was out with the Hayward rep and struggled to get it going. They were finally able to get it flowing by shutting the return jets 90% and diverting to the water slide which is a smaller diameter pipe. The tech said the reason was that the...