Search results

Much appreciated!

Yep, sure will

I was going to replace with Diverter W/ Gasket 272512 or just replace with the Pentair 272531 Hi-Flow Top Valve Assembly. The broken part does not come out.

It is not my pool light leaking. The open pipe is my overflow from the the pool. It is my valve losing water to the backwash. Thanks

I was going to change my diverter after finally figuring out I was leaking water to my backwash, but then I notice a piece below the diverter appears to be broke. Do I need to replace the whole valve or will just replacing the diverter still work? Not sure what this piece is. Thanks

If you are talking about the overflow hole in my original pic? I don't believe it is from that, because my pool loses water below that overflow drain.

I'm confused, is this correct, An open PVC pipe? Water was coming out when the pool was running. I capped it, but why would there be an open PVC pipe?

When I pulled the wires from the light, I put expoxy in the hole behind the light, not sure how good of a job I did. So, there is an exposed open pipe beneath the juction box in the ground that can be capped?

I disconnected my wires to my pool light a couple of years ago and filled the hole with expoxy. It is now leaking into my yard behind the junction box. My question is to permanently seal it, should I dig a hole behind the juction box to cap it or is the leak usally because the pipe is shattered...

Thanks

I replaaced my motor. Is this good? I connected my old bracket that the screw broke off or do I need to place the actual wire underneath the screw?

Stupid question, but can you plug the hole on the impeller? Or do you know the equivalent impeller without a screw hol to Pentair Whisperflo Impeller, 1 Hpl, - 073128 ?

Thanks, I'm trying to replace the motor, diffuser and impeller parts. I'm very confused on the motor shaft. There is no hole for the impeller screw on the shaft. Am I using the wrong impeller or wrong motor? The motor I am replacing was EUSQ1102.

I bought a new motor and was about to connect the impeller, but can't figure out how to hold the shaft in the back of the motor. How are you supposed to hold the shaft inplace?

Not sure how to check it. My backwash/waste pipes out to the city.

I added stabilizer to the skimmer basket and then noticed my water level started to drop while the pool is running. It seem to get a little better over the next few days, but I waited like 72 hours and backwashed, then I really noticed the water level would drop. Any ideas would is appreciated.