Search results

I have HDX 5 way test kit. I adjusted the PH today: was at 8, and I added 10 ounces of PH down for a pool of 15000 gallons. The pool indicates 2800ppm. A friend tested the pool with his test kit he got from your site and it came up at 2.5ppm I’ll test it again tomorrow to see how much the PH...

Thank you so much for your kind patience! I changed the yellow fuse which was burnt. The screen now indicates the chlorinator is at 50%. I assume this is normal?

And what about the two other ‘points’ you circled on the back of the panel? Should I solder these more?

what do you mean by check? should I press on them to make sure they are well in, or remove and put them back in? Moreover, I noted that I have a set of pare yellow, pink and purple ones attached to my manual. Are these additional spare ones given when we got the machine installed?

ok. Thanks

So the CSM comm error is fixed (I disabled the Chemical system monitoring as we do not have one) I still have the - 'no cell power' showing Here are the different pictures

ok but then why do they say in the video that depending on the volume of the pool we need to put T-9, T-15 or other T-?? I am just trying to understand the system better. Thanks

ok perfect. Thank you. After calculation, my pool is in between 14800 and 15300 gallons (kidney)

It is between 14800 and 15300 depending on the calculator. My pool is kidney but both loops of the pool are the same size (no smaller end and larger end)

ok thank you!

thank you. I don’t have this. I replied on your other message. In any case, the check system light turned off!! THANK YOU!!!

I looked it up and we don’t have one. I disabled the sensing system and it worked. Thank you!! Another question though: in the tutorial you sent me, it says that the machine is automatically programmed to T-Cell 15 (default). Should I change it to a different value? I think my pool is 16000...

ok thanks. I removed all the scale I could see. So I’ll leave it as is. I guess I need to check it again in 3 months, right?

ok thanks. Where can I see if I have the sense & dispense system?

It is on the screen on the pool machinery monitor. I believe there are two messages: 1. csm comm error (see screen shot from the app: in blue) 2. no cell power (the pool monitor) For the first one, we have an app to see all the technicalities of the pool, lights and heater. Maybe it is the...

In the meantime, - we checked the electrical panel and no joint needed to be soldered; - we cleaned the cell (which is 2 years old): we just did a hand cleaning and hosed it. It looked clean. Tomorrow I’ll use some muriatic acid with a Hayward stand. Each time, the computer says that the...

Hi, I am a total novice in pool matters beyond backwashing my pool! I hope to learn a lot from this wonderful community. Happy to have joined TFP

Hi. I am a novice in pool maintenance. We openened our pool s few days ago and our hayward salt generator does not seem to work. At the begining i was not concerned because of the temperature but now the pool is at 62F. The computer says csm comm errot No cell power What does that mean? Our...