Search results

For me Only the Pentair Motors have been worth it. My Intellichem display went bad after 4.5 years, still working just can't see anything. My IC40 just went bad last week, it is the third time the cell failes in 2 years , Initially failed after a week, then failed 3 months later. Now its...

Just an Update.. I purchased that aftermarket light and installed it today I'll have a better understanding how it works tonight and I will provide an update. I did notice that the Intellibright board I pulled out had that thick copper backing that the OP mentioned so as I suspected, Pentair...

I replaced my spa and pool lights with 5G's in 2015. The Spa light is still working fine. The Pool Light, the Green LED went out after 13 months, decided not do do anything . Blue LED lasted another 2 years just went out last week. So I am left with a nice creepy red pool at the moment. I...

Yea, that's the first thing I had done when this started happening (before I adjusted the CYA) They are sending me a new probe. so we'll see how that goes

Did some test over the weekend . Put the ORP sensor in filtered water (I use commercial filters ) tested the water ahead of time and no chlorine at all. The pool reading at the time had a Chlorine level of 5 and was reading 642 on the ORP, the filtered water read 672 in one test and 705 in...

That is an outdoor pool What you saw with the SWG not coming on is exactly one of the problems I brought up. I will have 5 days where the orp readings are stuck in the 500-600 range then one day it will turn on in the 750 range and climb for 5-6 days then drop again. As far as the PH goes...

This is the last data I have (I can pull more when I get home) But this is the first week of march and CYA is at 40. There are worse weeks , this one has the ORP climbing to 900

Actually the CYA was near 0 at that time and that drop in PH (between 5pm and 6pm) was when I added CYA to see if that was the issue . I put the CYA back up to 40 but I still get the same reactions . Overall the PH is pretty stable. No one has been in the pool, no covers, no operational...

I had an Intellichem installed in December . It is an Acid Pump and it is controlling the Pentair Intellichlor through an easytouch 8. Everything seemed to work fine for the first 6 weeks, the PH and ORP were stable and predictable. But then the ORP readings started to fluctuate willdly...

I have the same setup with no heater and it worked ok for me. I have about 5 feet and a few turns beween my intakepoint and my cell. I originally had my Acid injected into the mixing chamber and my return was just before my intellichlor. I required a minimum of 2200 RPM to open the intellichem...

I purchased an Intellichem last March but was not able to install it until this December. I hooked the unit up using the mixing chamber as the acid injection point, tapped the Intake just after the filter and the return/acid injection point just before the Salt cell. My kit was missing the...