Search results

I have the same problem with my quattro. Currently using a combination of zip ties to hold the cover in place and replacing it with new zip ties each time I cut the ties, dump out leaves and clean it out. I'm waiting for a replacement latch to come in stock again.. Something like this...

For those interested, here is a picture of the finished install with the generic SWCG. This is about 2-3 weeks ago. It has been running well since then! After doing all this and figuring out the slowest speed my pump can run activating the flow switch (about 1580 rpm), I am thinking now that I...

Thanks all for the great advice. I had been eyeing the RJ60+ originally, but looking at the cost of that vs. the fact that I have a Pentair Intellichlor power center I started to look into the IC60. Today I found this generic IC60 cell that I believe would work with the power center I have. I...

Thanks! I was trying to figure out away without cutting that pipe, but I think with your cut locations I could probably reuse a part of the cut out section, just relocated to the left a bit.

Thanks! That's exactly the way I did it.. Check out my thread in the SWG forum: Advice on location for SWG in piping (and what model fits)

Yes, I thought about that but I think the heater inlet piping is in the way. I was trying to avoid having to cut/relocate that too. And, yes I know it's still chlorine. I meant that previous owner switched back to a chlorine adding pool. He must have switched back at some point before the new...

Hello, I was looking to get advice on how to DIY plumb in a SWG in my piping which appears to be very tight between the heater and the outlets to the pool/spa. I've included some pictures showing an overall view and where I think the SWG should go. I was looking at the CircuPool line and/or...

Trying a post with Gallery Embed photos.

This is a test post.