Search results

Not seeing anything the last few days!

I got it all back under control!

Yep, especially now with all the evap the fill water is practically a quarter of the pool daily lol. I keeed.

Honestly don't know. Grabbed one from Home Depot. Given these big flakes over a couple days I bet they were the latter.

Yep, fizzed away. So definitely calcium.

Here's my current poolmath this afternoon. This is most accurate. Calcium hardness is low so should I try to aim for that to be a bit higher in general? Or is it just continue to fight ph like crazy? That seems to have the most effect on csi in poolmath. We are also running our aerators...

Honestly? No big reason. I just want to turn over as many times as possible, and energy at night is super cheap) we also have solar during the day). We get a lot of dust and small little mesquite leaves and pollen in our pool a lot of the year. I probably don't need to run it so high so long.

Oh I meant the swg, higher percentage for 8 hours rather than lower percentage for 16 hours. I run my pump at high overnight, 50% daytime, and 20% at peak usage (3 hours) because I like to always have my water moving and sending junk into the skimmer. But I think I should kick up my output...

Thanks! I think trying to hit that spot I've been overrunning my salt cell, almost all the time, causing it to go off and on. Now we DO have a broken sensor on it but I think I need to dial back my brain and pump it higher less often.

This sounds like I am doing a few things stupid. Fix me again.

Thank you!! This is not accurate currently. CYA is at 60, but it wouldn't let me update. Salt is currently at 3900. PH currently 7.5. FC is 8.5 as of today. But this was my most recent (other than the CYA not letting me update and salt after I added some).

We are having a warranty issue with our salt cell. It is intermittently working. I've been keeping the water clean regardless. We also just had the cell cleaned as well. However we had to get out of town for a couple of days, so I tossed a bleach tab in my skimmer to hopefully keep everying...

Tested salt today and it was 2400, salt is a pretty easy test as the change is instant. However salt cell says it has 2900 average salt. Which do I trust?

It is kind of upside down. It isn't bypassing the heater. I have replaced the sensor and now it is heating up. But I also think there is a reversal of the pool and spa in automation (not reality) where it was stopping at the pool setpoint, but running spa mode. So I changed the setpoint...

A few angles

Upside down meaning the teeth up or down? And where does it seat?

OK I ran into a snag here. Got it ready to be replaced nut I don't know where this washer goes. They sensors all ready to put in, but where does this need to be? When I try to install it and did a leak check, the silver sensor pushed up and out so clearly that washer was in the wrong spot...