Search results

Thanks all. I am starting to think that this is a system issue.

It doses automatically using Sense and Dispense. It has timed out after 60 Minutes at least three times today. The set point is at 7.8 (calibrated) and it keeps rising to 8.1.

I am using both the TF 100 test kit and the Lamotte Color IQ 2x. Both have been consistent with one another.

Hi All, I am experiencing some PH rise ever since I increased my CYA from 52 to 62. When I was at the lower CYA, my PH would basically sit at 7.6. These are my current readings. FC - 5.7 TA - 69 CYA - 62 PH- 7.8 and rising. CH-395 I am wondering if anyone has any advice about how to find the...

This is a great response. I have a S&D system running in tandem with a SWG as well. My ORP was never higher than 5mlv. The best fix is simply to revert back to the manual adjustment settings. It is easy to do and your manual will tell you how to configure the settings. I do, however, like the...

Awesome! Thanks!

Hi Chris, what did you use to pry up the tiles.? The travertine is heavy and I am concerned I might break it.

It’s a stone base. I am going to see if I can pry a tile or two up. And that is what I am hoping - it’s just bad compacting. Thanks for the response.

Hi all, My travertine near the skimmer has sunken considerably. Initially I thought it was just settling. During the install, they had to dig a hole to attach the bonding wire after the fact at that very spot. However, this is started to look like a water issue. The first picture was take in...

When they sprayed the bench seats, the leading edge dried quite rough (the picture below is shown wet). I appreciate the response. It sounds like this stuff will all work itself out once finished.

Hi all, I was hoping someone could educate me on how a new gunite shell is prepared for application of Pebble Tec. As you can see in the pictures, the plaster surface was left rather rough. This was sprayed last week. Will this be smoothed prior to Pebble Tec or just sprayed over the existing...