Search results

Did any of these fixes work for you? I have a similar issue. I have one screw that spins but it doesn’t look cracked inside the housing.

Jim, thanks for the response. I like the F-4 (I think that's what that is). So it sounds like you agree the problem is likely the valve. I'll give those two things a try and see if I see a difference, thanks for the tip. I'll rebuild it.

Short question: How do I test a 3-way valve for a suction leak. I get a lot of air in my system if it is set to full one direction or the other, very little if it's anywhere in the middle. Long Story: I recently bought a house with a pool. I've had a few issues with the suction and pump. The...

But why is the SWG still not producing chlorine? Is that a separate issue? It's giving me a code 94, but I assume that is because there is no amperage. --Well I fixed it-- it was just a blown fuse. Not where it was depicted in the manual though. Had to remove the faceplate of the control unit...

Thanks will get back to you after work. I just cleaned the cell today, and got the pH back down.... still no amperage out of it. Hardness is 250 Chlorine is a 1 right now... need to get that up ASAP without the SWG pH is now 6.8... need to increase that a little Alkalinity is 100 Cyanuric Acid...

Hello, after a few rains and dust storms my pools pH got really high without me catching it. Now the SWG is not producing any chlorine (very low amperage (0.01) and higher than normal Voltage (28.0)). Is this just becuase the pH is too high effecting the conductivity of the water? I hope so...