Search results

James, you're truly a TFF expert. As soon as I read your reply about the 3-port valve going into the heater, I thought right away it all make sense. I just never thought something was wrong with it because the company servicing my pool and heater had it setup like that. Bought the house 2.5...

There are error codes in front and no unusual LED indicators lit on the back of the panel.

I just approximated water flow based on the pump RPM. I opened the pool 3 weeks ako with freshly cleaned filter with psi running from 22-30 depending on the rpm. The pressure gauge is also less than a year old. If I were to get a flow meter, where should I install it (before or after the...

I did a bunch of troubleshooting today. 1. I removed detached the terminals from the termistor and got an E01 error code on the panel. I connected my old termistor and got a reading of 85 degrees. When I hold it, the temp slowly went up to 90. I then reconnected the terminal on the new...

I'm trying to upload a 32mb mp4 video file, but it's too large. I actually strip the video from 600mb. Anyway, it cycles as soon as I turn the heat on. Burber ignites and try to heat water for a few seconds and then lights turns off, temp will count up fast from current temp 75 to about 124 and...

I have a MasterTemp 400 that I have been troubleshooting since last year. I've check different foruns and looks like a common issue, but I have yet to see a resolution. Perhaps you can help. As soon as I turn the heat on, I see a 75 reading. It 'heat' blinks to call for heat and then steady...