Search results

Quick update - disconnecting/cutting the green wire was unsuccesful for me. I still had my original IC40 that was replaced under warranty and installed it. It was what I used as my placeholder over the winter. This cell reports salt levels to easy touch, but the inspect cell is flashing...

Moved from here. Does this solution also apply to the IC40? I am experiencing same exact issue. In addition, after holding "More" for three seconds and all percentage output LEDs flash green which I have interpreted as a bad flow switch or bad thermometer. Also, would you recommend the...

Replacement IC40 hadnt been cleaned since being installed last May after original failed under warranty. Pool when being measured manullay was showing 3000PPM while SWG/ET was and only showing 2100. Water Temp 70 degrees.

Support ticket open > Warranty Service came out made no changes HP runs fine without RS485 running, but with RS485 enabled water sensing > runs fine for a couple of minutes then error is received. Per EasyTouch > Heat Pump Only enabled > no errors when going through diagnostics. Wire from HP...

EasyTouch with IntelliChlor and UltraTemp H/C120 Installation. Firing up HeatPump for first time this year. Heatpump Turns on performs > temperature check > and then goes through 5 minute warm-up period. It appears that it is receiving heartbeat messages from EasyTouch (flashing asterick). When...