Search results

Finally, here is the pic after firmware flash!!!

Tech is out to flash v3.05 and will get a picture later today after he is done… Vr Roger V

Yes sir, will do!!! vr Roger V.

Thanks much Jim!!! Hooked everything back to orig, and pump is now working with automation!!! Also, I can adjust the settings on the IC-40 from the main panel and confirmed I could read the changes from my Screenlogic App... Pool installer is sending a guy out later this week to flash a new...

Yes sir, copy all!!! That was my intent (power off), but wasn't sure about the which plugs where... I just swapped the plugs and the yellow/green is now in J20... After power back on, took about 20 or so seconds for "Schedule" to kick on, but it did, and pool pump started with automation...

So I don't screw anything up any further, here's what I am seeing and reading... First, want to make sure the attached picture is "indeed" the Surge Card!!! Then, from EZTouch8 board, I unplug J20 connector that has 4 wires connected... I then unplug the same cable's other connector from...

Thanks Jim!!! I am attaching a picture of some things marked up on the EZTCH8 Board... I only see one COMPORT, and that is connected to the surge card by 4 wires... I am pulling that connection from the EZ8 board??? I have what looks like the power cable, pull that white plug or turn off...

Everything working perfectly on the pool and automation, just came home from 2 week trip to notice pool pimp wasn't running at 3pm in the afternoon. Go out to look and spa water is already starting to have a greenish tint to it, so pool pump hasn't run in several days... All other options that...