Search results

Thanks will give that a try.

Thanks. The skimmers must tie into one line. I used dye at the end of last season but could not find a leak at the skimmer plates.

I've been losing an inch or two of water each night with pump off. Water loss will stop at bottom of skimmer. Plugged both Skimmers and water stopped leaking. I assume it's in the piping to skimmer but don't see hole. Any advice and what would you use to close the hole? Thanks 25K gallon...

When I opened the pool the SWG showed salt reading of 3,000. Now it shows zero and check salt light and check cell light are on (not flashing). Checked salt separately showing 2800, changed flow sensor but lights still on. SWG is about 4 years old, the cell has been cleaned. Any thoughts...

Good news is that I redid the suction side and removed the bubbles and loss of water in pump. Bad news is the pressure continues to rise, although not as much as before. Filter has been cleaned twice. After cleaning pressure is 19 but rises to about 25 after a few hours.

Water is cloudy. The pressure after cleaning is 19 and after an hour or so up to 30. The water is mid way on skimmer but no vortex. There are bubbles coming out of the jets. Thank you.

I have cleaned the filter, lubed the O-rings. As pump stays on the water lowers and pressure rises. I cannot find a leak and cannot get water in pump to rise to the top. Any advice? thanks

Thanks for the replies. The Cell is now in it's second year. Is there a way to reset panel?

I am using an Aqua Rite Salt generator 40 . The reading on the control panel reads 3,600 ppm, the results from a Taylor K-1766 salt water test twice came in at 2,800 ppm. Which reading should i use and if i add salt should i worry if the reading on control panel gets to high? Thanks

Thanks for the reply. Salt is showing 3800.

Hi, I'm new too. I'm curious about testing. I bought the Taylor 2006, I've been testing the water with consistent results. This past Saturday took the water to three different stores for testing and got three different results, with all three different then my test. I wasnt sold anything but...

Hi, I'm new to this. I just got a new Aqua Rite 40,000 generator, I have been running it 8 hours daily with 0 FC PH 7.7 Alk 100 CYA 70 Hardness 220 Added 2 gallons of 12% shock last night with generator running at 75% output. Tested FC today at 0. Panel showing generating, voltage about...