Search results

My Hayward 350HDN pool heater is 6 years old. Last fall it started giving me the HS code which means the output water is over heating as I can tell by the boiling water that created rumbling sound then shuts down. I have tested the ohms per the manual on the temperature sensor so the next...

Yesterday my Hayward 350HDN turned off and displayed the HS error code meaning the temperature is too high. I turned off the breaker and restarted it and though I had it fixed after runner fo a few seconds I heard a rumbling sound and it shut off again showing HS. After restarting it again and...

I am reaching out before I take the leap on Monday to order $800 worth the parts I may or may not need. After spending hours researching this forum and others on the internet I have tried everything I can think of. The heater is natural gas and is 5 years old and has always fired right up but...

I opened my pool Three weeks ago, turned it on and the pump basket filled all the way up with no air bubbles. Slowly through the last three weeks it’s been getting less and less water in the basket now it’s 2 inches below the top I tried isolating both skimmer lines and just have a half hour...

I remember researching this last year when I was going to open my pool and didn't find an easy answer. I would like to share what I did this year and if its already been posted somewhere I apologize. We all know its easy to stick a shop vac hose in down the skimmer hole because the water...

I'm having a lot of problems with my Hayward TriStar leaking more and more every day this summer so I decided to take a look at it after watching YouTube video and the first thing I noticed was the diffuser ring was worn at an angle and appears to have melted into the diffuser itself creating a...

I opened the pool last week and turned on the pump and the basket would only get half full and low pressure. I took apart all unions and the pump lid and drain plugs and inspected and relubricated with no result. After researching this site I suspected the pump lid o ring and ordered one and...

I believe I havevthis wired correctly, the 104 side w orks fine with 120 v from 4 on the 104 and 120 v on two from the 106. When I turn the 106 on I get 120v from 4(common) on the 104 and 2 ( red low speed) and black line 2 high speed on 3 of the 106 resulting in the motor reset kicking out...

I have just hooked up my two hayward color logics to the intermatic 300 watt transformer and the second they flash on the gfi trips. Even when I disconnect the lights it still trips. I read what is below on a different thread. Is it sake to just use a regular breaker? Quote Originally...

I just back filled my DIY pool 2/3 and the pool is full and it just dawned on me that I ran my conduit horizontally along the pool wall with the plumbing at 30" below ground ramping up to ground level. This exposes about 60 feet of water filled conduit to freezing. Has anyone ever successfully...

I am about to plumb my 2 skimmers and 3 returns. If I make the elbow below the skimmers the lowest spot on the line from pump to skimmer after I take the water down 4 inches below the skimmer for winter, I could just blow out the lines and shop vac them dry correct? I am thinking about doing...

I have a Hayward Tri-Star 2 speed pump and just purchased an Intermatic T104R. After doing more research I see I should have ordered the T10604R. I assume this because you have to have a controller for each speed. From what I am reading it is most efficient to run the pump on low all of the...

Hello all! I am from northern Iowa where the winters are long and cold. I am building an in ground pool from a do it yourself online company. I haven't decided on a company yet but they all have about the same choices, steel walls or polymer with a vinyl liner. I like the though of steel...