Search results

Search the forum Search WordPress Search MediaWiki
  1. A

    Hayward Pool Heater FAIL (with pic)--new Heat Exchanger Available?

    Well I had a major Hayward Heat Master 250 ED2 pool heater fail at the rear manifold (cast iron part) yesterday (cracked big time). This is a circa 1990s Hayward pool heater (I bought the property in 2011). Once i got all the screws out during disassembly here is what I saw (I laid everything...
  2. A

    Changing Pro-Logic Panel after VSP to Dual Speed Pump

    Changed out a Haward VSP to a Hayward dual speed pump. The Pump runs great and really moves the water. It was wired per the Pro-Logic book....http://edc.poolsupplyworld.com/wpdf/plps-manual.pdf page 14 Top of the page. I went into the "Config" pages to change to the new pump "2-Speed" but I...
  3. A

    Hayward HM250 ED2 Heater "BOOMing" on start up

    Got on issue with my pool heater. When the command is sent to start I can hear the ignitor clicking away but it does not "fire" up like normal. After awhile it will go BOOM igniting all the gas from start. Any ideas?
  4. A

    Replacing SPA Light

    I've got a 120V SPA light that keeps tripping my GFCI on the ProLogic Panel. Drained the SPA and for kicks replaced the light bulb - yep, still no light. I pulled out the stainless housing and checked/inspected the light housing and saw a little rust near the cable outlet at the back of the...
  5. A

    Hayward HM250 ED2 Heater - "REMOTE" wiring to Pro Logic ?

    New to this great site full of info. Question. I'm trying to "remotely" wire my old Hayward HM250 Pool Heater into my Pro Logic panel. I've found plenty of manuals but nothing specific on where the terminal block is located inside the heater or a pic on what terminal posts to use on the...
Top Bottom
Back