Search results

Hi, Looking to purchase the cyclone and trying to see how I can modify the lid for easy blowout. I noticed the intelliflo lid has a curve as well as supporting ridges underneath which makes the seem hard to drill keep flush for the locknut and gasket. Has anyone successfully modify the lid...

Hi, I'm thinking of converting to SWG. I have Jandy automation and Pentair VS Intelliflo pump. For easy DIY I'm looking at Circupoll RJ series. I have two possible location. The first being right after the heater but I would have to put the flo sensor before the cell. The second is a...

Hi, I found a split on my conduit. Looks like the previous owner tried to repair it by inject some type of caulking inside it. I was wonder if there's a bracket I can purchase specifically for this. I didn't see any on amazon. Can I use super duct tape? Thanks!

Hi, I been meaning to setup my stenner pump and tank system which I purchased as a barely used unit. Unfortunately never got around to it and didn't open the pool this year. Looking to sell it as we will probably go with salt system after renovation next year. This is 120v unit. Looking to...

Hi All, I have an original controller that came with the pool about 15 years ago. It was built by Blue Haven and the controller says BH6100 which I believe is the same as Aqualink RS8. Last night the controller was dead, I tried to reset and looked at the wiring on the controller side. It...

Hi All, We just opened our pool today and tiles are falling off and red coping tiles are chipped. I already purchased pool putty epoxy for underwater tile repair. Can anyone recommend ways to fixed chipped coping tiles? They are the typical red bullnose. I've attached an image...

Hi All, I've been lurking for just under a year. We've moved into our new home July 2014. I just ordered my tf-100 test kit. Our pool was opening today and I'm ready to start maintaining my pool. Hopefully, I'll become knowledgeable enough to replace equipments as they start to fail...