Search results

Pool was a swamp, I decided drain it and start over. Do these white areas need to be completely removed before refill? I pressure washed it. It's pebble tech

I'm curious, I upgraded my pool equipment from a single speed to a VS (my signature is up to date) and added a salt system. I was under the impression that the point of a VS pump was to run as low as possible speed wise? With a freshly cleaned filter and pump at 90% speed I have 99.9 no bubbles...

Hello! I have a 3HP jandy stealth single speed pump that's coming out and a Pentair Intelliglo3 VSP going in, any advice before I start it?

On a pentair 520 cartridge filter, is it a good idea to put grease on the top black manifold under the lid?

43K non salt pool, CYA is at 108. % to drain to get to acceptable range?

I will be eliminating my D.E filter for a cartridge filter, Because that means re-doing plumbing I was thinking about adding a salt cell. Since the pandemic chlorine has been sold out 95% of the time so that sucks but at the same time it would be nice to have a more or less "maintenance free"...

I deep cleaned my DEV60 DE filter (opened it up and cleaned the grids of all waste/D.E. I put everything back together and recharged with D.E then noticed I had no air in the pump basket which I've been batteling previously (possible suction side leak) and my filter pressure stayed at 20psi...

I understand the suggested water testing kits mentioned here on the forums, I wanted to know if anyone has had any experience with the Lamotte Waterlink Spin Touch and disks. I always have a terrible time with colors so looking for a digital solution to just test and have a # and call it a day...

Trying to setup the pool calculator app and it's asking what pool type. I've tried looking up what pebble tec is and not getting a clear answer. Anyone assist?

Are you suppose to be able to blow air through the side shown into the opposite side or is it suppose to be sealed similar to a check valve aka 1 way valve?

Lid pops up when pump is off and has a net as well. There is an eyelet going to the pool and seems like a skimmer as it has 2 holes down below. Any ideas?I have a skimmer next to it so it's not the skimmer

I have iAqualink along with solar on my roof, I recently gained knowledge of the GL-235 from a family member so I acquired it and a valve for control of the 3 way solar valve. My question is with the water sensor, I already have a water temp probe in line after the filter and before the solar...

I put the pool into solar mode and the pipe on the roof is blowing apart.

I've seen on here not to take store advice, do you have to wait in between chemicals for a time period or can you add all at once?

Is there suppose to be an o-ring on the pipe that goes into the Jandy DE 60 Manifold? There is a place for 1?

ive got air under my lid (JVX300 pump) all plugs are closed tightly on the pump, my buddy had it as a spare so I swapped my pump off to eliminate pump as the possible issue running my in ground pool (40'x20') its the size of the lid viewing window, I've changed all 3 seals (2 smaller on shaft...