Search results

I want to see the settings on my Pentair Intelliflo VSF (it is connected to an Aqualink RS & iAqualink controller) but the display on the pump says "DISPLAY Not Active!" I've tried temporarily disconnecting the RS-485 but it still says "DISPLAY Not Active!" None of the buttons does anything...

My Hayward/AquaRite T-Cell-9 appears to be failing (it's about 6.5 years old) and I'd like a second opinion. Readings on salt have been all over for the last week or 2 (from 700 to 2800 with instant between 0 and 3100, store test showed 2800). It appears to work with sane readings (including...

I have bubbles in one of my returns and would like some help determining the source. I recently replaced my pump and added the iAqualink. The bubbles were there before and I was hoping the new pump and plumbing would resolve it. When I run in spa mode, there are no bubbles at the spa returns...

I just replaced the controller board on my Aqualink (old controller board was J and had issues with my spa-side switch, replacement is MM and runs the switch correctly). After the swap, the Aqualink does not seem to recognize the Aquarite and the Aquarite "remotely controlled" LED is not lit...

I just noticed that my chlorine is 0 and after a bunch of rain it's time to resolve (diagnostic voltage and amps are both 0). A couple years back (June 2016) I replaced the thermistor on my board and it was totally split in 2. I just went out and removed the cover and the thermistor looks ok -...

I just bought a new Jandy/Zodiac spa side remote switch (4 button 7443) to replace the old one that failed years ago (sun deterioration followed by a short, presumably). Before fishing the line through, I connected the terminal (wired the same as the existing one) and plugged in to my...