Search results

  1. S

    Having trouble putting the cap back on a Hayward cl200 clorinator.

    I have a Hayward cl200 in line chlorinator which I only use occasionally when I go away. In general the cap has been a pain to close and line up with the tab. Since I was back I went to put in the last two tabs that I had but no matter where I started from when putting the cap back on i could...
  2. S

    Adding cya directly to pool by mistake

    I am closing my pool up and I was balancing off my chemicals. I was going to add a little more calcium which I should have just left alone but I instead I added cya directly to the pool because I was distracted. I have brushed most of it up. And don’t see much on the pool floor. Tomorrow I was...
  3. S

    Skimmer repair working with epoxy.

    Hi, Sorry if this has been asked before. I have a plaster pool 28,000 gallons. One of my skimmers has about .5-1 inch crack at the very top where it joins the top piece and is 1-2 inches long. I don’t have a picture of it as I my pool is not open yet which I am going to open this weekend. I...
  4. S

    a little Loctite Polyurethane Sealant in my pool

    Hi All, I am not sure if this is the right place for this, my apologies if it is not. I am getting close to closing up my pool for the season and I noticed a couple of small spots in the expansion joints between the coping and the deck that needed to be redone. The decking needs to be re-done...
  5. S

    Questions using an In-line Trichlor feeder and water chemistry

    I have a couple questions regarding the use of Trichlor tabs using an in-line chlorinator. The questions are listed below if folks would like to skip the background, sorry if the background is a little long but I think I over thinking this instead of keeping it simple but I would like to...