Search results

Always kept at 50-60%

1. I had Low salt light & inspect cell lights on 2. Added bag of salt 3. After few days checked the indicators same lights 4. added another bag of salt (stupidity) 5. Again the two lights came on 6. Removed the cell & put it in bucket with muratic acis + water 7. dipped the cell with cable part...

hi water temp is around 85 regards

I had salt reading of 2200 , added one bag reading went to 2300 , added another bag reading show 2500 1. Cleaned the filter 2. Cleaned the cell in water + muratic acid 3. Did set the reading (Auto, OFF , 5 times , Super Chlorinate , auto) Now the display say 2500 as salt & Low salt & inspect...

I will sir

Thanks all for reply, Assuming I have leak and not visible above the ground , what are my options !!

No that's the only noticeable thing. You could be right because if it was leak then in summer Jun / Sep I never notice drop in water level.

Since October no rains here in Orlando. Since then my pump runs 6-7 hours daily I noticed my water level has gone down about 4 inch. I check pump are no visible leaks , however in the house closing / inspection report I have invoice saying the distribution valve leak was fixed ($120), I...

Back in the business, replace digikey part & got power & generating LED Now the display starts with 3.0 instead of 3300 for salt level , any suggestions !

Yes I ordered from Digikey : SL32 2R025 Ametherm | 570-1062-ND | DigiKey

No flow swith lights for 1 minute Generating light for 10 seconds My reading 3.0 28 5.2 keeps on increasing 0.00 57P -0.00 AL.0 r 1.40 Then on LED blank/off

Sure I will post all readings tomorrow

Found it , what is the Digikey part number !

Any video or pictuires how to fix it ?

How do I check transformer output ! I dont have any device !!

Thats what I thought and asked this question. Generating should be ON because CELL power wire is just fine.. Also alll other wires are in distance and safe and no damage

Visibly nothing is damaged nor loose but you are right it might be damaged

Yesterday I was weedwacking & my flow switch wire got tangled in my wacker. Now on the display I DO NOT have any LED's No power / No Generating What could be the cause & what will be solution ! Thanks,

I have tiny crack near guage indicator. When I replaces the guage indicator , I used the tape on thread. The leak is very minor but how can I fix it or I have to replace the whole head ! Regards

Thanks XeXys

The new model has fin on bottom white circles where as my old ones are flat , hope this will work

The white seals around valve at bottom is coming off, its there but worn off. Yes those bottom circles do not turn they just block/allow the water flow to diff. channels. I am seeing the price around $169 online (good !) Regards

I have in ground paramount 6 module. When I start the pump all heads pop up, but only 3 out of five get pressure. On the valve pressure gauage does not move (may be bad). When I shut off pump all heads go down so there is some movement. I took out the value & washed it couple of times...

All three are super idea's , thanks, Already used last one.

Yeap

Super solution , when I see picture , I guess hmmmm why I did not think about it ? Thank you Sir

My pool pole wholes have become big & brush & net keeps coming off any solutions !! :P

Sorry I posted pictures on wrong thread. pool-stains-t70305.html Mod Edit: I moved them to your thread here (just above this post). Moderator linen

Pictures of my pool One is 8Ft floor with black dots second one is 4ft clean floor Thanks :evil: Note: I used FastStone photo resizer (Free) you can reduce your file size by 90% without loosing anything.