Search results

tampatommy - it goes over my head too!!!!! I go back and read, reread, re-reread, just to make sure i got things right. @MyAZPool - I talked to pentair yesterday - In regards to the setting for the heater(s)....they said the way they work is that the heaters work off of a heat pump "preferred"...

@MyAZPool Couldn't I use the spa portion of the "PS" model for my sitting area? Treat it as a spa and use the "return" actuator to change the valve from pool returns to spa jets? I know I wouldnt need the "intake" side of it. Just thinking about it while my pad is setting! Let me know

So, theoretically, I could use the "return" pin socket........but not the intake? and i am still a little perplexed on how to run plumbing to heaters? I am going to order the expansion board (with load center) and gas heater later today. I will try to get an answer out of Polytec and I will...

Intake...........you mean like a main drain?

@MyAZPool In regards to wiring and relays, does anything change in regards to whether i have the PS panel or P panel?

got it.....I understand the disclaimer!!!! LOL. I think everything you have done is way above and beyond what I would get from a licensed electrician!!! But I do know a couple of them and for sure would have them review it. Surprisingly the inspector for my city even told me if I have any...

I am just thinking about all the transformers in a box. Wont heat buildup be an issue?

Lol. I was just going to comment on that! good catch. Question? What is the little box looking things that are around some of the line sides? Are those "wire nuts" joing wires? And then a pigtail to the breaker? Question? I already have a surge protector on my meter. I also have on for the main...

@kimkats @bdavis466 @MyAZPool Nothing like a cold one!!!!

Pardon the Christmas decorations!!!

@kimkats @bdavis466 For your viewing pleasure: First one is my test piece........then a paneled it with a special acrylic that allows light to pass through it. So you edge light it and the panel glows.....then place a translucent stone over top - such as this onyx and BAM!!!!! you have a back...

Wow.....impressive I have to ask - what background do you have - because it sure looks like some to of engineer? And Question? How do we power up both panels? I was originaly going to drop a 80 amp breaker in my panel in the garage, send (2) #4 hots and a #8 neutral and a #8 ground as feeders...

Look up NDS or stegmeirer products..........typically that is what gets installed

You mean this!!!! I built this last year. I will show you the night photos, when it is lit up!!!! And NO - I AM NOT BACK LIGHTING THE TABLE IN THE POOL!!!!!! LOL

@kimkats If the large piece is cut at 3' x 4' with a mitered 45 degree on the ends.........we cut 2 of them Then they cut a "border" any thickness i want. and that is what gets glued to the outside edges of the big piece. By doing this we can give the appearance of any thickness we want. I...

Today's progress.............These guys are beasts!!!!! Looks better than i could imagine..........and it is not even clean!!!! Back to work tomorrow!!!!!